Ok, so you are using ANSYS own light-weight scheduler (ARC). All machines using same credentials.Īdditionally I've found that if I run: arcconfig node modify %COMPUTERNAME% -mn maincad so test in RSM will go in schedule mode, but if I replace my master node with %COMPUTERNAME%, a test will go through fine. These 3 services running on each machine in cluster:Īlso I've tested telnet to port 9195 and SMB in Windows, there is no issues from OS perspective. This is after I deleted credentials for cluster01 Note: I'm not sure why, but Service Management running by cluster02user. There are a screenshots with my config below. I was thinking there is some incompatibility between my 3 machine cluster and R2, so I did reinstall OS on master machine (maincad) that using to send tasks to slaves in cluster, install R3 on it and install R3 on slaves, then replicate settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |